Advanced settings doorbell

Is a page of the app that has options that are not changed frequently. Usually this page will be used either by professionals only or to setup necessary settings for the first time.

To get to this page here are the steps:

1. Choose the dbell you'd like and press the "Setup" which is indicated by a gear symbol on the right side in the main menu page.
2. Select "Advanced Settings".

Language: dbell announces confirmation in the selected Language in setup mode. You may select other language for the announcement. Mute turns off the voice prompt along with the ring when you press the dbell button. Note this does not mute the "Chime" but only the video dbell.

Network Connection Status gives you specific information needed to connect your dbell in other ways such as a browser or an NVR system.

ONVIF Settings: Are for Network Video Recording systems (NVR) that allow you to record the stream 24/7.

Email Settings: This is the area where you would setup your email, in order to receive an image notification of someone pressing the doorbell. To do this, make sure that "Email Event Photo" is toggled ON. This will make sure that whenever an "event" such as motion detection is triggered, a snapshot picture will be taken and sent to the email you set up.

Date & Time: This section allows you to change the date and time that's displayed on the dbell stream. Whenever you take a video or picture, this time will be shown on the saved message. This could be important in criminal cases or for leisure, simply knowing when the recording happened.

Status Light: This is the heartbeat of the dbell. Blinking blue light simply means the dbell is on and internally functioning properly. You have the ability to turn this light off should you like to do so, by pressing the toggle on/off. To reach this toggle, open up "Settings" which looks like a "Gear" symbol.

Restart: Selecting this option will restart the doorbell. This will not delete any existing information that you have on the doorbell. Your doorbell will simply turn off and then go back on in a short duration of time.

Firmware: Firmware is a software that controls your dbell. Please make sure to always keep this up to date as we patch changes frequently.