Video settings

Video settings should only be changed by the professional. We recommend to keep the default video settings unless you are a video pro.

Video settings

Video format:

• 50Hz: Vertical Frequency 50Hz / PAL
• 60Hz: Vertical Frequency 60Hz / NTSC

Video Coding:

• Baseline: Baseline is suitable for low delay
• Main profile: Main profile provides better image quality.
• High profile:

Resolution:

• Main stream: 1920 x 1080p or 1280 x 720p
• Secondary stream: a) 640 x 352p b) 320 x 176p
• Third stream: 320 x 176p

Bit rate: 32-6144 kbps

Maximum frame rate: 1 to 30fps. Lower frame rate is better in poor Network condition.

Key frame interval: 2-150

Bit rate control:

• CBR: CBR adopts constant encoding bitrate
• VBR: VBR adopts variable encoding bitrate

Image quality: 

• 1: Best image quality
• 6: Lowest image quality

OSD(On Screen Display) options:

• Display time: Enable/Disable
• Time display location: Location of time stamp - a) Upper Left b) Upper Right c) Lower Left d) Lower Right
• Show camera name: Enable/Disable
• Camera name location: a) Top left b) Top right c) Bottom left d) Bottom right
• Camera name: A name assigned to your camera, like South camera, North camera

Video parameters:

• Brightness: Default value 50
• Saturation: Default value 0
• Contrast: Default value 60
• Sharpness: Default value 70
• Exposure: Default value 44
• Gamma: Default value 3
• Distortion: Default value 0

Flip: Flip video vertically

Mirror: Mirror video horizontally

WDR: Set WDR ON or OFF. WDR enhances the image quality in bright light source (sunlight, lamps or reflectors, etc.) , shadow of high-brightness, backlight.

AEmode:

• Auto, Default setting is recommended.
• Indoor
• Outdoor

Image mode:

• Frame rate
• Illuminance, Default setting is recommended.

IR LED Control:

• Auto, Default setting is recommended.
• On
• Off

Shutter: 1 to 10000, Default setting is recommended.

IR Cut: 1-1024, Higher value faster switching time. Default setting is recommended.

Noise: 0-100, Lower value reduces most noise. Default setting is recommended.

Audio Settings

Audio Compression Type: Audio compression format:G 711, G 726

Audio settings: On or Off. Turn on or Turn off audio of IP camera. For audio to work, external speaker and Mic is required to be hooked up. If audio is not required Turn off audio to save DSP and network resources. Audio is disabled by default.

Audio Input Type: MIC or Line In

Input Volume: Adjust the Mic volume.
Output Volume: Adjust the Speaker volume.