Cleaning Clean dbell immediately if it comes in contact with anything that may cause constant electrical short circuit like salt water, acids, solvent etc. To clean:
- Turn off dbell by disconnecting power or turning the breaker off. Disconnect all cables.
- Use a soft, slightly damp, lint-free cloth—for example, a lens cloth.
- Don’t use cleaning products
Exposure to water and dust If water continuously splashes on dbell or constantly unusual amount of dust gets on it, wipe it off with a soft, lint-free cloth (for example, a lens cloth) so that your dbell lens is dry and free of dust. Minimize exposing dbell to water, acids, salt water and solvents. If dbell comes into contact with any of these substances, follow the instructions above in the Cleaning section.
dbell is water, and dust resistant and were tested under controlled laboratory conditions with a rating of IP65. Splash, water, and dust resistance are not permanent conditions and resistance might decrease as a result of normal wear. Liquid damage not covered under warranty. To prevent liquid damage on dbell, avoid the following:
- Continuous rain on dbell
- Exposing dbell to pressurized water or high pressure water
- Using dbell in a sauna or steam room
- Intentionally submerging dbell in water
- Operating dbell outside the suggested temperature ranges
- Dropping dbell or subjecting it to other impacts
- Disassembling dbell, including removing screws to view PCB
If your dbell has been exposed for a prolonged period to liquid, unplug all cables and do not connect your dbell until it’s completely dry.
Do not dry your dbell using an external heat source.
Using connection, ports, and buttons Never force a connector into a port or apply excessive pressure to a button, because this may cause damage that is not covered under the warranty.
DC to USB Cable Use with stand USB charger like Android or iOS charger with 2000mA output.
Operating temperature dbell is designed to work in ambient temperatures between -40° and 158° F (-40° and 70° C) and stored in temperatures between -4° and 113° F (-20° and 45° C). dbell can be damaged if stored or operated outside of these temperature ranges. When you’re using dbell it is normal for dbell to get slightly warm.